With the press off and the Kompac lifted off the plate, the plate should immediately begin drying evenly.Tighten the Kompac to a slight drag in the slotted brackets to hold the unit in place.Hand operate the machine to ink up the Kompac and take an ink stripe.
Rca Wireless Receiver Ir Emitter Model D930 Treadmill Manual For ANov 23, 2009 1 Hi, Just wondering does anyone have a PDF version of an operators instruction manual for a Varn Kompac that is fitted.
Notice other sites using numbers such as 360990 or HE-WI0990 for a gripper bar That was the numbering system created by us. Rca Wireless Receiver Ir Emitter Model D930 Treadmill Download Varn KompacVarn Kompac Manual Instructions Varn Kompac Manual Download Varn Kompac Unit Installation Manual Take the Kompac off the machine and separate the rollers. Bring the rollers slowly together until they just touch.- make a complete revolution of the rollers. Calibrate the unit: Separate the rollers with the numbered calibrating knobs, disregarding the numbers. Use two strips of paper to set a slight drag equally on each side of the roller. It is important to the operation of the Kompac that the rollers are as parallel as possible. Remove the small outer slotted screw from the calibration knobs and use a 332 hex wrench to loosen and reset the knobs to corresponding numbers. Replace and retighten screws with both knobs set at the number 1. John bunyan calatoria crestinuluiThe numbers on the calibrating knob should always correspond when the rollers are exactly parallel. Never operate the unit with the knobs out of calibration after they have been set correctly. With a plate on the machine, set the Kompac in the brackets on the machine without the spring. Let the Kompac fall down on the plate cylinder to assume a parallel position on the plate cylinder. There should be an exact parallel stripe across the plate. Do not Operate the machine under power without the springs attached.) If the stripe is not parallel tap the slightly tightened Kompac up or down in the slot until it makes a perfectly parallel stripe. With the plate still attached, operate the Press in the water position and adjust the unit to a very slight bounce evenly on both sides. Allow the form and fountain rolls to make contact for 10-15 seconds, place the single lever in the water position, use the hand wheel to make a rapid 14 inch turn opposite the nip. Use the manufactures minimum recommendation usually 4.0 4.5 acid and 5.5 6.0 alkaline. Drive genius 3 mac torrentAdd fountain solution to the Kompac and with the press operating at a slow speed drop the form on the inked plate. After dropping the Kompac rollers on the inked plate, the rollers should begin removing the ink evenly across the plate within 4-5 revolutions and clean the plate completely and evenly across in 20-25 revolutions.
0 Comments
Leave a Reply. |
AuthorJessica ArchivesCategories |